• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

amp wiring


mattr87

Well-Known Member
Joined
Jul 14, 2008
Messages
59
Age
33
City
roy, washington
Vehicle Year
1987
Transmission
Manual
hey im in the process of putting my amp in to my 87 supercab where the hell am i supposed to run my power wire thru the firewall. i cant find anywhere!
 
There is a rubber grommet up behind the pedals that I removed and my Pos. wire and CB antenna cable... Now that I think of it, that will probably cause some interference.....

It's a little more than an inch in dia. you can probably get to it from either side. You can poke a hole in it and put it back in to keep dirt out even.
 
you can do it the way mentioned above or you can go buy a firewall rubber grommet. get the that corresponds with the guage of wire your using. so if you have 4 guage power wire, use a 4 guage grommet. then you can drill a hole wherever you want.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top