alignment camber sleeves

[rusty7983]

I need an alignment. The alignment shop in my area I trust said he doesn't want to mess with camber sleeve install. Said its been a while and he just likes the quick in and out 45 minute alignments. He will do it if I install it. How do I get the old out and adjustable ones in? I am going to do a 4 inch lift and want it to be right. Should I throw in ball joints and do it at the same time? Or do they come out another way?

 

[brokemechanic3000]

You would have to either remove the nut on top of the balljoint or remove the pinch bolt that goes through the knuckle. Then use a chisel and hammer to pop the sleeve out, or hammer a chisel into the gap in the knuckle and then repeat the above step.When you put it back together make sure everything is clean and use anti-seize on the sleve.