Did a little bit today, got a flex a lite fan installed today, still have to make a shroude. Still might go to a electric fan. Time will tell. Also measured for a rear drive shaft, plan on taking it to a shop on Monday to get made longer.
Got out to the garage for the first time in a cople of weeks , install my hydraulic clutch setup, hook up my throttle linkage and did a little wiring. Here a pic of the set up I used for the hydraulic clutch.
Not in the same situation, but my rear half is roached on d side around the rear leaf mount & that whole side of the spare carrier is all but gone. Looking to replace. What size bolts did you use for the cross member rivets? I've done the springs mounts before, no big.
Side note to ALL New to owning a TRUCK: Remove the Spare from time to time & CLEAN OUT the road dirt & salt (States above the Bible Belt) to prevent this.
Keep at it. Your making good progress. Lots of us have to balance time and money on these things. I'd bet a lot of guys on here are watching you looking forward to seeing theirs run again. I am.
For
a small yearly donation, you can support this forum and receive a 'Supporting
Member' banner, or become a 'Supporting Vendor' and promote your products here.
Click the banner to find out how.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.