99 4x4 stock measurements?

[96Greenster]

Can somebody help me out with this, I need the stock measurements for a 1999 4x4 extended cab 4dr, 4.0L Auto trans, I trying to find out how much torsion crank the previous owner did. I have some 31x10.50x15" on it also, but doesnt matter too much. From the edge of the rim to the inner fender would be ok... Thanks

 

[red_98]

wonderng the the same thing. I recently did my t-crack, 2in bl, and 35's. And i want to know how much higher than i am over stock.

 

[Original_Ranger84]

I'll measure mine in the morning, same except I have a 3.0L... hopefully doesn't make too much of a difference. I have No crank and 31's sitting on 15x8's. You said measure from the rim to the fender right?

 

[Toms01PSD]

From the ground to the fender on mine is 36 inches with 265/75R16 tires. Basically the same as 31's. I had the Ranger lean so I cranked it up a little to even it out. It was just under 35 inches before I leveled it out.

 

[96Greenster]

From the ground to the fender on mine is 36 inches with 265/75R16 tires. Basically the same as 31's. I had the Ranger lean so I cranked it up a little to even it out. It was just under 35 inches before I leveled it out.

Cool! Thanks dude.

 

[LittleBigFoot]

If it helps, I think I'm like 36" to the bottom of the rockers.

But that's far from stock.

 

[96Greenster]

Well I just measured from the floor to the fender, it measure aprox 38" front and 38" in the rear. So I assume that the previous owner did crank the tbars. So I lowered it 1" so now I have exactly 37" front and 38" rear, 1 inch difference is good enough. Rides smoother NOW! Now I know what I have... Thanks Guyz.