Hey I have a 98 ford ranger that I’m swapping to a solid axle. Anyway I have a lot of Chevy parts motors and axles it there any way I could make a chevy axle work main thing I’m worried about is the front drive shaft
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
I was just worried about drive shaft hitting nice build thoOne of these engines is in my truck....
And it's not the small block.
View attachment 71078
You will need some steering....lots of ways to do it.....Toyota box is common. I like the old school 2wd Chevy box though. Outside the frame rail makes more room for engine ... This is a ford bronco box ...fullsize 78 to 79.
View attachment 71079
This is the junk pile that engine and steering box motivate.
It's can climb over 5 foot rocks....and haul my shit 1500 miles to work...
It's a POS..... But cheap and easy ...
Most importantly...reliable ...
View attachment 71080
Yup..
Helped big on eds golden nugget. I will probably be out there next week.
I love the Golden Nugget videos.Yup..
Helped big on eds golden nugget. I will probably be out there next week.
I see TRS2
Scan rightI see TRS2
Is that the famed TRS Jag? Did you get to ride in it?Scan right