• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

93 ranger fuel injector problem


slick7623

New Member
Joined
Oct 3, 2014
Messages
2
City
Simi valley , ca
Vehicle Year
1993
Transmission
Manual
My credo
eyes open , no fear
I did a cab switch on my 93 ranger , after putting it back together it won't start. Fuel pump turns on , fuel pressure good , runs when I spray starting fluid in the intake manifold . I think it has something to do with the wiring of the fuel injectors ?
 
To test your theory, get a set of noid lights. They are relatively cheap.
You should have 12v on the red wire with the IGN on but the other wire, Tan or White, is a ground controlled by the computer. By the way, the computer is bolted into the cab from the engine bay side on the left. If you swapped cabs but did not keep the original computer then you may have gotten a Federal emissions computer mixed up with a California emmisions one.
 
Ya I kept the original computer I started with. I tested the injectors with a noid light, nothin. Replaced both fuel pump relay and the eec power relay.
 
Last edited:

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top