susieranger
Active Member
- Joined
- Nov 29, 2007
- Messages
- 30
- Vehicle Year
- '92
- Transmission
- Automatic
Anyone know how tight I should torque the front hub nut on my Ranger after packing the wheel bearings. Thanks very much.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
'92 Ranger 3.0 2wd Hub Nut Torque
- Thread starter susieranger
- Start date
Run it on fairly tight, but not gorilla-torque, while you spin the wheel.
Back it off so the cotter pin hole lines up. Done.
Back it off so the cotter pin hole lines up. Done.
no, its a 3 stage torqueing process, you torque it to 25ft-lbs while spinning the rotor to seat the bearings, then back it off 1/4 to 1/2 a turn, then torque it to 16-18 INCH-lbs, which is about finger tight.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
