• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

911 - Help Please with Transfer Case Removal!!!!


wizkid00104

Well-Known Member
Joined
Oct 15, 2007
Messages
1,720
City
West Newton/Penn Hills, PA
Vehicle Year
1994/2002
Transmission
Manual
My transfer case is stuck. I took out all 5 bolts and wd-40 soaked everything. I have removed everything needed to take the case out. My dad and I banged, wedged, pried, and smacked at the damn thing for 2 and a half hours and it is still stuck. We then strapped a tow strap around the case and to the back of my dad's ranger and pulled and jerked and for god's sakes and it is still seized.

I am soo frustrated. Please help!
 
Nothing else should be holding it on to the transmission except the output shaft. Usually with enough work it will break free. Sounds like yours is on there really tight.

Have you heated the flanges up? I've had to do that on my t-case before to get things to start breaking apart. Just be careful not to heat it up too much, it's only aluminum/magnesium.
 
are you sure you got all the bolts?? (not calling you stupid or anything, just double check) i have never had mine stick like that before. once its unbolted, all that holds it on is the gasket sealer.
 
I know. There were 5 bolts and the alignment pin. I got the speedocable and both drive shafts. I have no idea what is keeping it sooooo tight.
 
you might have a busted or slipped spline in the output shaft of the transmission i had a buddy with a full size bronco that we got so pissed we droped the tranny still couldnt get it so we used the cuttin torch to see the prob and the tranny and t-case splines had stripped and welded togather. Do you put it under enought stress to do anything like that??
 
I just used an acetyline torch to heat up the flange, and it came right off.

Like surffishin said, if the shafts are stuck together, you might need to get a cutting torch and cut the damn thing off. Try heating it with an acetyline torch first to see if it will break it apart.
 
When that happens it is usually the alignment pin seized. Pulling it with a towstrap will not do much because it won't be pulling straight on it. You need a very thin wedge to put in there and work it loose.

Oh and before you get too wild with it I would loosely thread 2 of the bolts back in. That way you don't have to worry about it coming loose and falling off when you least expect it.
 
Yes, all five bolts are "head forward"

That and the alignment pin are all that hold it on.

yes, sometimes the splines "Stick",

what I usually do to seperate the two is to use two "screwdriver handled"
prybars back to back and try the case off, you've just gotta keep working at it.

when you do get them seperated grease the splines.

AD
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Latest posts

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top