88 lifted B2 Clemson SC

[CU88B2]

I am a senior at Clemson University in SC, I have an 88 Bronco II 2.9l 5 speed, 6" lift (4"suspension and 2" body), 36" Super Swamper TSL SX tires, dana locking hubs, 4.10 gears, and much more to come. (It's not for sale I just haven't had time to clean it off yet)

Before the 36's (33" SS TSL)

 

[88_Eddie]

looks good. it wont last long on those stock axles, explorer axles would be pushing it as well. what are the plans?

welcome to the site

 

[jhammel85]

Very nice! I love the color

Welcome!

 

[CU88B2]

looks good. it wont last long on those stock axles, explorer axles would be pushing it as well. what are the plans?

I just ordered JD dual shock mounts and a stabilizer. 4.0l is going in this weekend may drag into next weekend as well. Using 4.0 clutch flywheel and starter (still kinda confused on the starter so im winging it) using my 5spd tranny and transfer case. I have a set of 79 bronco axles dana 44" and ford 9" but I'm going to wait till they break first to swap them (need to make some more money for the custom fab work) but any recommendations would be appreciated this is my first B2 and I have been reading like crazy but its the little things that end up causing the problems lol... Anyways pics will go up when I start the swap!!!

 

[88_Eddie]

lots of people have done then 44/9" swap and a lot have done the 4.0 swap as well. just search through the build threads and you'll figure it out pretty quick. i'm still in the middle of swapping my 8.8 and D35, so i wont be much SAS help.

 

[CU88B2]

Cleaned it up and pulled the 2.9l getting ready to motor swap, but I may be dropping a 5.0 driveline from a gt40 explorer!!!