4WD swap

[87_B2K]

I own a 1987 mazda b2000 i have acsess to an 89 ranger front end whole assembelly and a 1990 bronco 2 rear end with leafs and shocks was wondering if they will bolt up and if anyone had a cheap tranny i can put in it, must be a 5 speed thx

 

[87_B2K]

i also have a welder if that is needed

 

[87_B2K]

Wow people are tons of help 74 people have looked at this and none can even say a single thing

 

[kryptonitecb]

I don't know

Sent from the road while ignoring traffic

 

[armadillon]

I own a 1987 mazda b2000 i have acsess to an 89 ranger front end whole assembelly and a 1990 bronco 2 rear end with leafs and shocks was wondering if they will bolt up and if anyone had a cheap tranny i can put in it, must be a 5 speed thx

Can you be a little more specific? Which parts? The rear end? Just the shocks? All? A lot of us will skip over some posts if we don't know exactly what you're asking and if you don't provide a lot of details. That would mean we have to go look up the info ourselves which...we think is the original posters responsibility. As for a cheap tranny, you need to post that in the Parts Wanted section and specify which transmission because nobody is going to see that here. Before you ask which tranny you need, check the Tech Library. Also, posts fly by pretty fast if there isn't a response to it, so it's no surprise that theres no responses.


Everything will bolt up with a welder.

I don't know

Sent from the road while ignoring traffic

LOL!

 

[Snoranger]

Bolt up, No.

An 87 Mazda is a Mazda, not a RBV. The rear axle wouldnt be any different then any other axle swap, but the front... thats a whole different story. Its not a Ranger frame.

I have to assume the biggest reason you didnt get an answer in the time frame that you deemed acceptable is that this is mainly a Ranger site, most people dont know much about the older Mazdas.

 

[adsm08]

Did they even make a 4x4 Mazda B when they were still Mazdas? All the ones I've ever seen and looked at closely were 2wd.