4.0 bellhousing to block bolts

[Funnyman141]

I need to get the spare 4.0 on the engine stand but the bellhousing bolts have seemed to have disappeared I'm just wondering what thread and pitch the bolts are.

Thank you.

 

[adsm08]

I believe they are 8 x 1.25. Buy long ones and a lot of washers, the factory bell bolts aren't usually long enough to mount it on an engine stand.

 

[Snoranger]

I believe they are 8 x 1.25. Buy long ones and a lot of washers, the factory bell bolts aren't usually long enough to mount it on an engine stand.

You mean M10 X 1.25.

 

[Funnyman141]

Alright, I'll get both and try them out and post up which one works.

 

[adsm08]

No, I just took them out of the B2 today, they are 10.

 

[Funnyman141]

yep they are M10x1.25 and the longest ones in stock are to short for the engine stand.

dam but thanks for the help you two.

:EDIT: M10x1.5

 

[AllanD]

try again... they are 10mm X 1.5mm

AD

 

[Funnyman141]

well damn, there is one bolt hole that is cross threaded i guess , Thanks AllanD

 

[Snoranger]

try again... they are 10mm X 1.5mm

AD

That explains why the bolts were tight all the way out on the last 4.0l I pulled. Good thing the block was junk anyway.