I have a 94 4.0l explorer 4x4, if Im swapping in a 4.0l 4x4 M5OD, will the old A4LD block pate work in front of the new flywheel? Its 4.0 to 4.0 with the same starter. Thanks.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
4.0 A4LD to 4.0 M5OD
- Thread starter Ag0229113
- Start date
Shran
Junk Collector
TRS Forum Moderator
Supporting Member
Article Contributor
Solid Axle Swap
Truck of Month
No, you need the M5OD block plate.
Any good resource or part number? I'm striking out looking around for it.
Shran
Junk Collector
TRS Forum Moderator
Supporting Member
Article Contributor
Solid Axle Swap
Truck of Month
F07E-6A373-CC
Junkyard, maybe get lucky on eBay, or the want ads on here. 90 up Ranger w/ 4.0, 91-probably '01 Explorer are your donor vehicles. I don't know when they stopped using that part but I'm guessing up to at least 1997 is very safe.
www.therangerstation.com
Junkyard, maybe get lucky on eBay, or the want ads on here. 90 up Ranger w/ 4.0, 91-probably '01 Explorer are your donor vehicles. I don't know when they stopped using that part but I'm guessing up to at least 1997 is very safe.
Wanted - 1st/2nd Gen M5OD Cylinder Block Rear Plate Separator
I think I may have 3 or 4 of those plates you’re talking about… I believe the ones I have are anywhere from 1991-2009…. I’ll look
Similar threads
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
