- Joined
- Nov 28, 2024
- Messages
- 3
- City
- Frankston, TX
- Vehicle Year
- 1989
- Engine
- 4.0 V6
- Transmission
- Manual
Putting a Dana 35 from a 93 Explorer into my 89 Bronco II and need a set of 3.73 gears. Anyone upgrade and have a stock set laying around?
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Found! 3.73 ring and pinion for Dana 35
- Thread starter aj351w
- Start date
- Joined
- Nov 28, 2024
- Messages
- 3
- City
- Frankston, TX
- Vehicle Year
- 1989
- Engine
- 4.0 V6
- Transmission
- Manual
I’m in Frankston TX. I have an 8.8 rear end with 3.73’s and limited slip from a 2wd Explorer. The 4wd Explorer I’m using for the front has 3.27’s and open rear so I’ll use the 2wd’s rear and just need to replace the Dana 35 gears to match the rear. Long story short I just need front gears to match the rear.
Similar threads
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
