1991 Ranger Seats to 1988 Ranger Seats Direct Fit?

[mihulka3]

Can anyone tell me if a 91 split bench will drop into an 88 with no drilling?

Thanks

 

[Mark_88]

Should drop right in, but not sure about the drilling...the outside mounts should, hypothetically, be OK...but the inside mounts are a maybe...but drilling the floor and reinforcing the holes with some good washers (welding them in is recommended) and then using grade 8 bolts to secure them will do the trick...

I think, though, from what I've seen, most holes are pre-drilled and reinforced because if it was an option on that year of truck then it's just a matter of the seats being plunked in at the assembly line...have a look under the truck (so you don't have to remove the seats) for pre-drilled holes...just to make sure...

 

[mihulka3]

Thanks

Thanks for the reply. I will investigate further. I can pull the seat out of a junk truck and movethe 91 to the 88. I'm trying to avoid doing so if i can get an answer.

 

[country0001]

Should go right in. The differences start comin in when ur talkin reg cab vs. extended cab.

 

[xkotyx]

all the holes should be in place from the factory, even if they didnt use the particular hole

 

[adsm08]

You just need to swap tracks and it will go right in. I have 91 seats in my 87, just used the 87 tracks.

 

[mihulka3]

Thanks

Thanks for the replies.

 

[xkotyx]

no problem! good luck too, doubt youll need it. haha