• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

1988 2wd ranger/ 1991 4.0 swap


bentwrnch55

New Member
Joined
Apr 27, 2009
Messages
1
Vehicle Year
1988
Transmission
Automatic
been reading about swap not clear as to how much of the 1991 wiring harness to remove/ will drive shaft forn 91 work/ how much of 88 wiring harness do i use
 
The first two things you need are:
1)a 1991 Ranger EVTM
2)a 1988 Ranger EVTM

Right behind that is a large bag of heat sealable
RED butt splice crimp connectors and a crimper.
You will need a smaller bag of the blue ones and seven
to ten of the yellow ones.

Several single edge razor blades and a large sack of wire ties

You actually need to split BOTH harnesses and use part of each,
keep the horn and light wiring from the old one and essentially
shitcan everything else.

But you need the EVTM(s) to determine what to connect to what.

My recommendation is to use as much of the new harness and as little of
the old one as you can get away with.

You will also need to remove that metal panel on the inner fender that the starter solenoid and relays are mounted to and mount the small under hood fuse and relay
box in it's place.

If you were "local" to eastern Pennsylvania you could come and study my truck
(an '87) into which I swapped 1993 explorer engine and wiring into..

It was to most people an "ugly" job, creating "neat" appearance and results.

AD
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top