05 Edge V8 Swap

[hoosier1104]

I believe the problem primarily lies is in getting crank power to the wheels through a 4R70W AWD setup.

Sent from your Grandma's closest using Tapatalk 2

 

[hoosier1104]

Ok a little update is needed.

After reading about the 4.6 swap in the Tech Library, I have decide to revisit/entertain the idea of the 4.6.

After talking with Pete for a while today, I have up with a very basic parts list

1. Mustang Cobra SVT Terminator motor (this one depends on width since it is a dual overhead cam motor)
2. Mountaineer AWD complete drive train
3. F150 4.6 trans w/ transfer case
4. Corresponding engine harness and ECU depending on motor selection

Decisions decisions decisions

 

[escort_gts]

Do the swap on another ranger. Leave yours a 5.0

Sent from my HTC VLE_U using Tapatalk 2

 

[RangerSVT]

Well, Kevin and Ryan on trucks (power block) did it, and I remember someone else modding the ac box for the 4.6 dohc. I'm actually considering transplanting a mark 8 drivetrain into my sport Trac...


SVT

 

[hoosier1104]

That air box mod one is in the tech library.

Sent from the front seat of my Ranger while looking damn good.

 

[hoosier1104]

Do the swap on another ranger. Leave yours a 5.0

Sent from my HTC VLE_U using Tapatalk 2

I might do that. I think a Gen 1 with a 4.6 laying frame would be sweet.

Sent from the front seat of my Ranger while looking damn good.

 

[dangerranger83]

I agree, do it to another ranger. Your still not done with what you have now. But if you are going to do it to a gen 1 all going to do it to a 4wd or 2wd?

I would do it to a 2wd and finish the awd you were doing to your current one.

Sent from my rooted SPH-D710 using Tapatalk 2