troubleshoot

Okay first of all, thank you to everyone who has helped me this far. I’ve finished rebuilding my transmission and am pretty confident in it at this point in time. Truck drives forward for the first time in 24 years! I have one problem however, it seems to be shifting wrong. Not late nor early...

96 ranger 2wd 5 speed 160k Cabin is very buzzy and vibrates pretty heavily at idle. Can also hear noise from engine either sounds like cam spinning and hitting rockers, or fan hitting shroud but can’t find signs of either. Oriellys motor and transmission mounts a month ago new double plat...

Originally my Ranger was in a no start condition where it would crank but no life from the injectors or sparkplugs. The original owner had already replaced the ignition control module and had had no success. When I got the vehicle I went ahead and replaced the wiring harness since the original...

I installed this product as described in the instructions. Red wire to 12v constant, brown wire to key on 12v, black wire to ground and purple wire spliced into black wire on O2 Sensor cable. The unit does not work. When I disconnect the unit the backlight will flash for a split second and turn...

Need some advice on how to go about fixing this issue. I am getting codes 116 & 114 also but I think that is due to checking while the engine was cold. Getting code 998 as well which I think means the truck is running in default mode. Truck started cranking sluggish and if it is REALLY cold...

Hello everyone. I'm having problems with my 97 ranger running rich. It has the 4.0 ohc engine with a 5 speed rwd. It's throwing the following codes: p1132, p1152, p0135, p0141, and p0155. They indicate heater circuit malfunction on all three o2 sensors and that both banks are running rich...