transfer case

I have a 2000 3.0 with live axles up front and the module behind the radio. 4x4 system went dark a couple years back and I'm getting around to fixing it now. A buddy used his diagonstic tool to pick up code P1867, implying a contact plate issue with the tcase motor (although I've read this can...

Recently I was trying to get into 4wd but my rear wheels were the only ones getting any power. I have manual locking hubs and a manual shift style transfer case. If I select 4wd on the transfer case, it still lights up the light on the dash, and says low range if I choose 4 low. I don’t really...

I've been dealing with a rattle/ chatter noise from directly under my transmission tunnel, just behind the shifter. its in every gear except for fourth, and in 2 hi 4 hi and 4lo. i just replaced the transfer case today after i thought i had determined the source of the noise being it. i also...

Looking for: a manual shift 1354 transfer case, from a 90-97. (With transmission plate and boot/ shift knob) Rear axle, limited slip, 3.55 gears.(code r5 on info tag) (8.8) Rear sliding glass, for a super cab (compatible with a 91) Complete Rad support, 83-88 Leveling kit, for a Dana 35. 2 ish...

I currently have bw1354 with 1310 front cv driveline and would like to swap out the 1310 yoke for a yoke that takes a 1350 u joint has anyone done this if so do you have part numbers for a seal and yoke? And has anyone done it to the rear yoke as well this way your not using a combo I joint...

I’m looking to tcase swap my 1991 manual 4.0, with the electric shift 4x4 (manual hubs thank god). My electric shift really hated the cold snaps this winter, and as a result of using it my 4hi no longer works, and my 4lo has become 4hi. Honestly, I don’t really want to diag as I still can use my...

Hello everyone, as you can see this post will be about the transfer case and a problem with the 4x4. I tried looking up information everywhere else, but I could not find any sources relating to my problem and resorted to posting about it as a last resort in hopes of getting it fixed. For...

Hey all, I have a 2000 ranger 3.0 4x4 ext cab that the engine recently blew. (which I cant say I i'm too sad about). Anyway, I purchased a 5.0 from a 00 mountaineer with only 90k miles, it includes the entire engine, wiring harnesses, transmission, computer, and other small things. I spent a...

1992 sclb Located Lexington, SC Seats -sold Door panels with power window cutouts- sold Trim - sold Seat belts - $20 each 4wd module for push button 4.0 auto, untested. $15 Ttb d35 axle, 3.27 gear. $100 or trade for 2wd beams 1989+ Transfer case still in car, $150 Auto trans, still in car -...

I came across this manual while searching the web. Thought others would find it useful too. BW 1350 and 1354 https://drive.google.com/file/d/17C331PrWNfkvQOGyJ12Hrf3gQ_YnzobV/view?usp=sharing The link was found on this page https://www.car-repairmanual.com/transmission/

Ok so the other night I was out on a dirt road and came across an area with about 2 1/2 feet of snow. Basically just to the under side of the motor. Anyways I came to a stop and moved 4x4 selector switch to 4h. When it lit up I tried to move. Nothing happened except what seemed to be tire spin...

I have a 98 ford ranger. I’m on a tight budget doing solid axle swap and have Chevy transmission what ford transfer case bolt up to Chevy tranny

I have to say I Love my stock 2004 Arizona Beige Metallic 4x4 Ranger, but I am about at my wits end with this truck. When in 4wd, high or low, there is a horrendous banging noise coming from the driveline and multiple shops (including several dealers) cannot seem to be able to figure it out (one...

Is it normal to have the e-selector button tray on the dash in tandem with a manual transfer case lever? The buttons are blank, no 4x4/Low written on them, but there's have a noticeable click when I press them. From what I've seen on junkyard Rangers, there's usually a fake vent that goes...

Hey guys,new here. So i purchased this 89 bronco ii back in the winter time and its been a great little ride, 2.9 Auto and 4x4. Well here recently ive been hearing a little bit of a loud noise which it sounds like its coming out of the torque converter. I have also noticed, even when i first...

So I want to swap a 302 into my 83 ranger and I’m thinking about using the T5 transmission but I want to know if I can use 4wd with it. Do I need a special adapter? Is there a T5 that can fit the transfer case ?

Hey all, new guy here. I'm looking forward to being an active member of this community. A little about me: I'm a 30 something ecologist who lives in Eastern Washington. I use my truck to commute to work, and I sometimes use it as my work truck. I also use it on the weekends for camping and ski...

Howdy everyone. I’m having some very troubling issues with my ranger. I snapped 2 of the tiny 1210 u joint on the rear drive shaft wheeling. I removed the rear shaft and used the 4hi with the front drive shaft to get home. When driving to the drive line shop I hear a loud crack/pop and all my...

Picked up 99 Ranger 3.0, reg cab, 4x4 automatic the other day. 90K miles and it looks pretty good. It ran rough, and the transmission shifted poorly, and there were no dash lights to the 4x4, and no transfer case response. I suspect the GEM is bad, as there are other electrical indicators...

94 ranger 4.0 manual push button manual hubs. When I push the button nothing happens other than my headlights dim for a second. No 4x4 lights light up even when I turn the key on and start it up. I did the push button test and the light blinks like the book says. Seems that all my fuses are in...