crank no start

Hi all! I’m 19, and new to diagnostics. This is my first post on the forum, so forgive me if this already has been touched on in the past, but I’m really trying to get my baby back on the road Sequence of events so far: -Driving down the road, WOT and the engine cuts and dies -Crank, No Start...

Truck: 1993 Ranger XLT SuperCab, 4.0L OHV Problem: cranks strong and healthy, never fires up. Not even a cough. TIMELINE THAT MIGHT MATTER: I had the bed off the truck. While it was off I repaired a chafed fuel line and replaced the pump. Bed went back on and the truck ran fine that day —...

So I just thought of this. Would having swapped engines out of a 93 ranger into a 92 ranger require me to use the computer in the 93 as well?

I’ve replaced my crankshaft position sensor twice now, replaced both coil packs, DIS module, and a couple other things and still cannot get spark from the coils. Not sure what it is Any ideas? Truck is a 92 Ranger 2.3 5 speed XLT

Driving on the highway, truck stalled wont start. Fuel? Nope, new filter and a full tank, the inertia switch not tripped. Fuel filter runs, the relay is new. Truck will not start with quick start sprayed into throttle body.. Spark? Replaced the plugs, and tested all for spark, weak spark on...

Hi. I'm a new owner of an old Ranger. and the biggest problem i'm having with it is trying to figure out why it starts fine in the morning, then once its up to running temp, it wont restart after it sits 10-20 minutes. i get a crank with no start. it'll run on starting fluid until it runs out...