1999

We’ve replaced the fuel pump twice and still aren’t getting it to kick on, we’ve tested the relay, inertia switch, and checked voltage at fuel pump connection and voltage seems to be good. Any other reason the fuel pump wouldn’t kick on even if it’s getting power??

So I’m replacing the fuel pump on my 99 3.0 V6 flex fuel. I noticed on my original fuel pump there is an extra filter, but on the new pump I just bought it’s not there. Is this filter necessary? If so where can I find a new one? Any help is greatly appreciated!

Hello ranger danger guys i have a 99 ford ranger 2.5 liter. Just did maintance (coil packs wires spark plugs) truck is runing good but when im at idle and i gas it in nuetral and comes back down starts misfiring. When i go to gas it runs excellent . Im looking for some knowlagble answers for...

1999 ranger that I bought two years ago to learn the DIY basics. Turns over great, new battery, spark plugs and leads, cleaned the air flow sensor, but still have intermittent starting issues, maybe one time out of seven. Some times cold start, some times running hot (like when I stop for gas...

I have a 99 ranger which recently lost four wheel drive due to the vacuum system not working as it should. I just tried to bypass the whole system by just locking the hubs. However, after doing this, while in four wheel drive even with the hubs locked after a couple minutes and I let off the gas...

Hello. I am looking to clear something up on my 1999 Ford ranger XLT 3.0L Gas Engine. The temprature gauage in my truck is not working. So after investigation I am of the understanding that there are 2 parts. (1) the ECT Cooling Sensor for the computer and the Temp Gauage Sender(not sensor) for...

Hi Ranger Experts, I'm considering purchasing a '99 Mazda B2500 SE 2D for $3,500. Manual transmission, 87,000 miles, no rust, in great aesthetic condition. What worries me is that according to the TRS buyers' guide, 1999 is a really bad year for recalls/general problems for the Ranger. And...

Hey guys irish_ here new to this forum and I'm hoping that maybe yall could shed some light on the topic for me I have a 99 2.5l manual ranger that I want to swap to a v8 I was wonder what should be my donor vehicle and what am I going to need from it and how exactly I should go about doing it I...

Hi All, I have a 1999 Mazda B4000 ext cab (1999 Ranger 4.0). The rear cross member that goes frame to frame at the back of the fuel tank is rotted out. I need to order a replacement so I can fix, but I don't know what part I need exactly. Can anyone help out? Thank!

This problem has been around since I bought my Ranger, but it also comes and goes, so I always end up forgetting about it but now it seems like it’s back and is going to stay. When it first started misfiring, I replaced the MAF sensor, air filter, plugs and plug wires, and it ran perfectly...

Hello there! I bought a (well) used '99 Ranger in Sept. of 2016, and have been replacing parts as I've gone along. Unfortunately, something new has gone awry and it has me stumped. The truck's been running a bit rough lately. A la, chugging at stops, including rocking of the engine and the...

The front bumper of my 99 ranger xlt is bent, and i'm looking for a cheap or diy fix, not a cheapskate but parts are expensive and I can do it myself I will. I've wanted a custom from bumper for it but never knew where to look for one, that being the alternative to fixing it or diy fix it till I...

I Built this in February as my regular beds front cross member was rotted out. Figured I would get more use out of a flatbed. Around $700 later, I have myself a new bed. Comes in handy around the farm. Thanks for looking.

My 99 Ranger has had the CEL on, tried new gas, tightened gas cap...the simple stuff. Went to AutoZone to find out it was a p0453. They told me the part is $84.99, it's an FTPS2 - they said it would take a few days to get to the store. I have limited knowledge of this sort of repair. I've...

Ok here is the deal. I have completely ran out of ideas. So last year my air worked just fine, ok. This year I turn the A/C on from inside the truck and, well nothing. We get the auto kick on and off of the compressor when you start the truck, but that is it. So we have tried jumping the...

Well let's start for the beginning I was driving home from work one day and I get on the interstate and it work shift into overdrive the the o\d light starts flashing I continue to drive it home about 20 miles. By the time I get home I barley make it into the driveway just stops no gears at all...

I have a 1999 Ford Ranger XLT 4 Door Extended Cab 4wd and I'm looking to buy new speakers for it. an audio shop near me told me the speaker size is 6x9" but other sites have said 6x8" please let me know ASAP

I've looked over the forums, and tech articles and cant seem to find the answer to my question. So if someone could point me in the right direction, I'd appreciate it. I have a 99 4.0 4wd xlt, it has pvh hubs, the bearings in the wheel assembly are going out, my question is: Can I replace...

so I put a new trans in my 99 ranger. everything went together pretty good and fluid is full....or so the dipstick says..( checked w/engine running) put truck into gear and nothing... pulled the 2 lines off that run to the trans cooler... not pumping... I did fill the TC before the trans...

so I have a 99 ranger xlt 2wd ext cab auto trans 3.0 engine putting a different trans in the truck. TC went in transmission first and clicked in 2 times. put trans up to engine...everything lined up... put 1 bolt on either side of trans. ( where the alignment pins are on the block) i turn...