1993 2wd 2.3 ranger
When I jack up the truck and move the wheels at the top and bottom back and forth. There is a clunk and small movement. It doesn’t move side to side.
wheel bearings are good.
ball joints seem to be fine as there wasn’t any movement when I grabbed the spindle and tried to...
If you have a bad wheel bearing on the front drivers side, can it cause the 4wd to fail? Both front brakes were just replaced.
Thanks in advance, Amarissa
Hi all,
I have a 1999 Ford Ranger XLT 4x4 that needs the front wheel bearings replaced.
Is there a difference between a left-hand drive and a right-hand drive?
I'm in Australia so any parts I can purchase are for right-hand drives. The car I have was bought in America and is a left-hand...
I have a 96 ranger xlt with the 4.0 L 4x4. The wheel bearing is going out I need to replace it but, I don't know what axle I have. Its either a dana 28 or 35 I believe. How can I tell without taking the whole thing apart first?
i have a 95 ford ranger 4x4 and when i am driving down the road i sounds like a wheel bearing but i have replaced the wheel bearings.. The noise is still there.. when going over small hills there is squeeling and then the truck kinda jolts.. any ideas on what this could be?? thanks
Hey guys, so I blew out the wheel bearing in the front passenger wheel of my truck. I'm no mechanic, and only have the most basic of tools at my disposal. Just wondering if anyone would be able to give me step-by-step instructions on how to replace this. Thanks in advance!
Jerrot
Hello everyone! I was recently replacing my front brakes on my 03 Edge (with a haynes manual) and I had no problems getting the rotor and caliper off, but sure enough I couldnt figure out how to get the Inner grease seal out of the old rotor of for the life of me! The haynes manual says just pry...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.