coil spring

Hello, I am installing a set of leveling springs (+1.5 inches) on my 1996 4x4 Ranger. I currently have managed to extract the old spring. However, I am having trouble slipping the new springs in. So far I have removed the shocks, the sway bar end links, the old coil spring, and the tie rod ball...

So I’m trying to find the parts I need for mid to long travel front suspension. However, I’m finding that every kit or parts list with pictures that I can find in whole of the interwebs doesn’t look the same lol. The coilspring is literally through the freaking frame. How tf do I upgrade that...

I own a '99 XLT with coil spring suspension and I have already changed the lower ball joints but I'm wondering if the upper ones are replaceable. I was about to buy some new ones but the listing says coil spring upper control arm "WITH replaceable ball joint". The thing is, the passenger side...

I just bought a 1993 Ranger XLT 2WD with 215,000k. I'm told it needs some front end work, and I'm wondering if it would be good to replace or update the coil springs leaf springs while I'm at it. Is there a ready way to see if the springs are still up to spec, and if replacement is warranted, is...

Just installed Moog's cc866 coil springs today on my '93 Longbed 2.3L. These are rated for the 3.0 and 4.0 V6 trucks. I wanted as heavy as I could get to attempt to counter "the lean". (a battery move is next) I had read on this site that the expected ride would be much stiffer, however, it...

Hey guys, got a 98 ranger 2wd 5 speed.....I have done a 3" spindle lift on the front and 2" shackle w/ 2" block kit and its time for new shocks ( currently have lift shocks from fabtech) and was curious if I did a 2" coil in the front would that improve my ride quality with maybe a bigger...

Although this is my first post, i have searched through these forums time and time again and still have a few questions. I want to do a 3-4" shackle lift in the rear and already have those fabricated. In the front I want to do 4" lift coils or 2.5" coils with a 1.5 or 2" coil spacer. Any...

So I'm working at building my 07 Ranger. My question is; Can I swap my coil spring front end with a torsion bar front end from an 02 without any fab work? I'm trying to build in stages so this will allow me to put my tires, fiberglass, and bumpers on while deciding on which suspension I want to...

I recently purchased a 3" coil spacer and shackle lift for my 98 2wd ranger. I bought all new monroe shocks(stock replacements) and lined them up with my motorcraft shocks I took off. The new monroe shocks are about an inch shorter, and I am not sure if they will be long enough with the amount...