abs

Greetings fellow ranger enthusiasts, I have a 1993 Ford ranger which has the ABS light illuminated in the dash. I read a code of 4(Yellow REAR ANTILOCK Light Flashes 4 Times Red Brake Warning Light Iluminated RABS Valve Switch Closed or Open Dump Valve) except the red light isn't illuminated...

So I'm new here I've read through a few threads that seem to be about very similar issues and I'm still chasing my tail it seems like so i said "Well, you don't know what you don't know until you know that you didn't know it." And if that statement makes sense to anyone i might be in the right...

HI I HAVE A SITUATION WITH MY TRUCK ABS AND BRAKE LIGHTS ARE ONE, I ALREADY REPLACE ABS SENSOR AND PIGTAIL. THE 4 TIRES ARE IN THE CORRECT PSI AND BRAKE FLUID IS FULL. COULD YOU HELP ME?

Hello Everyone, I would like to know if any of you all have a clue what is going on with my truck. I have a 1992 Ford Ranger and I have already got the code, it was a code 3 I believe it went ..._ . I replaced the RABS Control Module with a fresh one after going through the mechanics...

Hey there, I have a 1990 Bronco II XLT 4x4 that has been edging ever closer to finish. I've recently replaced the brakes almost in their entirety for the rear and still after bleeding the entire system have both the yellow and red brake lights illuminated and I now have a flashout CODE 4...

Anyone know of a source for a replacement control module? Upfix does not do repair work on this model. TIA for any help of suggestions.

the orange ABS light and red BRAKE light are on 100% of the time, brakes work and stop good, parking/emergency brake works good. ABS does not work. i am going to replace ABS speed sensor, and if that doesn’t work the control module. if all else fails then i know it’s the ABS hydraulic valve...

I have a 95 Ranger XLT 2WD 4.0 that seems to have a electrical issue. It has 38,000 miles on it. It never holds a charge on the battery it seems, but if you go to jump it off, it comes to life right away. Literally you just touch the jumpers to it and it suddenly wakes up. Then once you start...

If I smash on the brakes, my 2011 Ranger will throw on the traction control light and store this code: c116a-e0. I can clear the light by turning the engine off and restarting it. If I mash the brakes again, it comes on. Right before the light comes on there's a physical "click" in the brake...

Hello I have a 97 ranger with 2.3l and the trans is a 83 mustang t5 v8 borge n warner both are manuals. I have got it all tied together with the local mechanic doing it very trustworthy n honest he quoted me $2200 n I got I was wondering what will have to be programmed out of the ecm or pcm once...

Hey all, 08 Ranger XLT 4x4 5 Speed, ABS kicks on at low speed. Ive narrowed it down to faulty speed sensor(s), as described exactly in this video https://www.youtube.com/watch?v=7ve-eoHph2M My question for you: is there a way short of going to a dealer or finding somebody with an expensive...

I have a 95 2WD manual, OBDII connection with an ABS light that stays on. Checked the fluid level and all is good there. In the hopes of a quick fix I replaced the sensor on the differential. OBD port is useless to check codes as my reader will only go back to 1996 for ABS codes. Any ideas...

I have a 94 Ranger XLT super cab 4x2 with the ABS light on. I pulled the code and I get a code 4 but searching the internet I can not find a list of what the codes mean. As far as I can tell this code means "RABS valve switch closed or open dump valve." This information was taken from a 91...

1998 Ford Ranger XLT 3.0L V6 (4R44E Auto) Do apologize for the long post, but want to explain everything that has been done so far. So picked up this little pickup recently and have been trying to figure out how to fix it. Body was in pretty good shape and only had 103,203 miles on it when I...

Yesterday my abs light came on and started flashing. It flashing a total of 16 times and from what I have tried to gather up thats code 16. Not sure what the code means. Any help on that would be appreciated. Later that day along with the abs light I found out that my dash light was not...

ABS Light came on 3 months ago. (96 XLT Ranger, 3.0L, Rear ABS, 7.5 RG) I was driving down the road (SC) when the rear Pass wheel locked up and left a line of tread 50' long and dug into the shoulder (dirt) when I pulled over. I turned off the engine, then turned it back on, and the wheel was...

Hello I am new to this forum but am desperate for help. I have a 99 ranger and the abs light is on speedo doesn't work o/d light flashes and it shifts hard. I have already replaced the speed sensor on the rear end twice thinking maybe the first one was bad. I've checked all the wires and...

Recently purchased 96 Ranger 4x4 3.0. Previous owners had Ford dealership troubleshoot their ABS. Wheel sensors replaced and the dealer says the final problem is in the control module. It's evidently in the dash. Have consulted two printed manuals and a Fort TSO- can't find how to access and...

Hi guys, got a fresh new problem to deal with. I have a 1999 ford ranger xl, single cab rear wheel drive. yesterday my abs light came on and my speedometer started to bounce. It engages around 60 km/h when accelerating, and when braking it will bounce down to zero once I go below approximately...

I think this is only my 2nd post here as you've all done so well pre-emptively answering my other questions :icon_thumby: But, now... I am trying to get a definitive answer on whether or not the remanufactured ABS control module I just got (BWD, from Oreilly's) absolutely needs to be...