Recent content by n_bannerman

Not sure if this should be in here or steering but I am having major bump steer with a leaf spring sas. Running a rear shackle setup with rancho 44044 spring set up spring under for a few months and have been fighting to get rid of the bump steer. Also when I corner hard it feels as if the whole...

Having trouble getting radius arms off of a d35 I just picked up. I've used 5 foot breaker bar with hitting the bolt with a sledge hoping that would work and also hit it time and time again with a battery powered impact. The bolts have been soaking in lots of pb blast for the last 2 days and...

I got my hands on a free carrier and have been thinking about welding it up. does anyone run a welded 7.5 for dd use and how do the rear shafts take the abuse? sick of doing one wheel spins front and rear when ever im in the mountains so its time to do something for the rear and this would be...

Half way point of removing the block on the rear of my truck and my u-bolts are not threaded down far enough, can I drill a larger hole in the block and run it ontop the spring pack till I can get new u-bolts? Thanks!!!! Nathan

What would I need to do to delete the egr and keep my 2.3 running right? I have had 2 go out on me in 2 years.

What model and year?

What would should I look under to find one?

Looking at both the 35x14.5 15 rockers and 36x13.5 15 iroks on 10" DIY bead locks, what would be a better snow tire? I know I can fit 35's but know I would have to do some more to fit the 36's.

Have an 86 2.3 that lost power to the fuel pump or the pump died. Trying to find the fuse for the pump but can't find it, where would it be hiding? Also I replaced both pumps and filters this summer.

So been fighting a issue with my clutch when it gets cold out side. Will work perfect at 35f but below 32 I loose pressure and can't find the leak anywhere. Any ideas what to check other then keep adding fluid?

The reason I was looking at doing it with leafs is $. I know an sas ain't cheap but I'm tired of fighting the d28 to get rid of the bump steer and to work properly. Around here, we mainly have toys with leaf sas's and they ride nice. I'll look into the link set up though. Also I've been running...

I'm also not going for tons of flex, I'm trying to keep it under 4" of lift if I can.

It's easy and simple. Other then the shock mounts and spring pads it's almost bolt on.

I know everyone says d30 are crap but all I will be doing is snow wheeling and dding it. What year jeep and model should I be looking at?

What does everyone use and recommend for a good impact socket set? I got a craftsmen 19.2 volt impact gun for Christmas and need the sockets now.