any measurements for fender flare holes

[94 lngbd]

I have a 94 Ranger that i'm up grading to have the 2003 front end. I have the fenders & also a 2003 bed to replace damaged 94 bed. I just recently got a complete set of EDGE fender flares & need to know if there's any dimensions for drilling the holes into fenders & bed for the fender flares to mount into?

Thanks in advance for any info.

 

[94 lngbd]

WOW, you mean that after 29 people looking at this no one has info about the locations of factory holes on bed & front fenders for factory flares!!

 

[whocares]

WOW, you mean that after 29 people looking at this no one has info about the locations of factory holes on bed & front fenders for factory flares!!

No. We all have the information....it's just a secret.

 

[RangerBoy94]

Here:
http://www.therangerstation.com/Magazine/January2011/98_clip_conversion.htm

 

[94 lngbd]

im referring to the holes that the fender flares clips snap into on the front fenders & the wheel openings on the bed

 

[Scrambler82]

PITA… I know, the holes are what is stopping me from putting the flares on my new bed.
It would be nice if there was a templet, tape it on mark the holes and drill but I have not found anything.

My thought is this, in a few weeks I will tape on my flares, get the position I want, both of them.
Mark the top of the flare with a thin edged, removable marking pencil and use that line to determine the position of the holes.
Both sides could be a little off from each other because who will see both at the same time but I think they will work OK.
next thing is new clips, right now Ford is the only supplier I can find, hopping that "Clips and Fasteners" will have something.

Drilling the first hole will be the worst part of it, the rest will some easy.

Luck.ltr,

 

[94 lngbd]

My bad as I forgot until today when I got my 2003 fenders out of storage that they already have the fender flare holes in them.

I will measure the distance that they are from each other & from the fender lip & post the info when I get that done ,but I still need the dimensions for the bed sides.

Called the dealer & asked if theres such a template & he said no but to use a big enough pc of cardboard & press fender flare onto cardboard to make indents from the clips & mark the edges of the flares & then I would have a template.

I may try that or put some wet paint on end of each clip & then set flare up against bed

 

[Agarza34]

Im bringing this thread back because I'd like to add the rear fender flares to my current bed that does not have any. Please anything helps, a template or if there's another thread elsewhere