Welcome Visitor! Please take a few seconds and 
85_Ranger4x4
Wallows in rivers
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS 20th Anniversary
VAGABOND
TRS Event Participant
My EMISS light came on. No biggie I thought, I have seen the bit in my Haynes manual about resetting it.
From memory: "Working under the dash, insert a screwdriver into the .20 hole marked reset..."
There are a ton of roughly .25 dia holes and none are marked "reset"
So I did a search and found this:
http://www.therangerstation.com/forums/showthread.php?t=20492&highlight=emiss
So I gutted the glovebox and flipped it down. There is only one module, a white one. It is only held on by one screw (as opposed to the two in the above post), is white and I don't see anyway you can do anything to it with a screwdriver. I unplugged it and it made no difference to the light.
What does this thing look like and does anybody have a pic of one installed/where you reset it?
From memory: "Working under the dash, insert a screwdriver into the .20 hole marked reset..."
There are a ton of roughly .25 dia holes and none are marked "reset"
So I did a search and found this:
http://www.therangerstation.com/forums/showthread.php?t=20492&highlight=emiss
So I gutted the glovebox and flipped it down. There is only one module, a white one. It is only held on by one screw (as opposed to the two in the above post), is white and I don't see anyway you can do anything to it with a screwdriver. I unplugged it and it made no difference to the light.
What does this thing look like and does anybody have a pic of one installed/where you reset it?
