wsup dudes, I have a 3 inch block and u-bolts for the read but for the front when i attached a 3 inch spacer and after it was installed i couldnt get the upper control arm to attach to the spindle. would it be easier to add some sort of drop pitman arm or should i just buy a 3 inch spindle lift...
Does my truck have the stabiltrac it’s a 2003 Ford ranger xlt 2wd does it have stabiltrac I want to order a spindle lift and it says it don’t work on stabiltrac models thanks
My ranger is misfiring on idle and doesn’t start right away . I got codes for cyl 6 misfire and bank 2 lean code
This is after I changed the injectors from brand new ones I got from autozone
The truck runs really good anything after idle
I unplugged every injector and they all shut the engine...
First post so I apologize if it’s badly formatted but I have a 1993 ford ranger 4x4 single cab with the 5 speed manual with 295 000 km and it has a issue where it doesn’t like to start back up when it reaches operating temperature. It’ll crank over fine but won’t start up the only way I can get...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.