I just replaced all of my ball joints and I have yet to get an alignment. When the front of the truck is lifted off the ground there is no up-down and side to side movement. But since tie rods are pretty cheap ill replace them before I get it aligned. My question is should I replace the inner...
You should see the following, the IAC assembly has two "ports" with the solenoid controlling the air flow between these two ports, what we want to accomplish is to restrict the airflow leading through this.
To do this, there should be a small gasket on your intake, or it could be stuck to the...
My obd2 scanner is showing my
MPH to be 0 at any speed.
02 sensors all show 0volts
also fuel map is running at -100%
Please help. Thanks. I also DON'T have a CEL on
What is the sensor called that is located on the passenger side of my manual transmission?
Edit
Sorry about the misspelling in the subject Im using a cell phone.
Ok. I have a few problems. When the engine is completely cold soaked when I go to start the engine makes a few loud chirping noises. This only last a few seconds. I put a new belt on to try and solve the problem but no luck.
Problem 2
when cold and being very light footed on the throttle the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.