I made a set 2 inch spacers for less than $15.
Was easy too!! LOL
picked up two 2 inch sections of 2.75 6061 T6 round bar from http://metalsupermarkets.com/ for $7 and change each and drilled a 3/4 hole in the center.
I told you it was easy. :icon_rofl:
Don't forget to swing by...
after installing f150 coils and bending the beams it was time to correct the caster. I was at -1.8 degrees caster on both sides with the stock radius arms.
I used 2x2 .250 thick and .250 plate and reused the stock studs and bushings.
Oh, and a lil' diff. than most, I center mounted the...
I knocked out the fake aluminum rivets and chucked the wheel up on the brake lathe at the shop.
I scraped the clear coat off the outside lips with a bastard file and also scraped off the bad curb damage.
Then sanded with 80, 150, 220 and 320 to get a brushed satin finish.
roughed up the...
I didnt really find alot about this when searching the site before starting to install mine so I figured I would share my "bro fab"
Been working on installing an RCI 16 gallon fuel cell and can between the rear frame rails.
I cut and welded a copy of Speedway Motors fuel cell bracket from...
Hello all. This is my second post. :icon_twisted:
I was turned on to the site by the guy I bought my 84 reg. cab from yesterday.
A lil' about me. I live in Vancouver WA and am a long time bracket racing fan. The ranger is going to be my daily driver while I work on my 74 Plymouth Scamp drag...
Hello all. This is my first post. I was turned on to the site by the guy I bought my 84 reg. cab from yesterday.
A lil' about me. I live in Vancouver WA and am a long time bracket racing fan. The ranger is going to be my daily driver while I work on my 74 Plymouth Scamp drag car.
But me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.