Recent content by JunkYardRanger

I heard that headers from the newer 4.0's in like the mustangs will bolt up to my OHV motor is this true ... Thanks

I know this is a little late but tomorrow December 6th Lakeland mudhole MUDDY MUDDY CHRISTMAS $15 per adult kids 12 and under free 8100 State Road 33 N Lakeland, FL 33809 I'm loaded up and ready to go!!

I know how u all feel about the A4LD but I do not want to hear problems with it I just want to know if my ECU from the 5 speed truck will work with an A4LD and if not what would I need to to to make it work the truck is a 95 4.0 and the trans came from a 92 Explorer someone please Thanks

Finally Done

Come the First of the year I am putting a 455ci BB olds in my 95 ranger .. should I make a complete build thread or just some pictures and yes I already have the engine .... here is a picture of me bringing it home .... the engine is a low compression engine only 8.5 to 1 I am leaving the engine...

I am not sure where to post this question ..... can someone with a stock height with stock tire 95 - 97 ranger 4x4 tell me how far the bottom of the door is off the ground if u look in this pic u will see the measurement I want Thanks

Click the picture for a slide show if that does not work try the link at the bottom http://w101.photobucket.com/albums/m66/techy78/?action=view&current=85fcba15.pbw

I would like to welcome anyone and everyone to the site that has recently joined. I have been a member now almost a year. I lurked around the site for a few months before I joined. I am currently a member of 3 other forum boards and have to say this is the most knowledgeable board I am part...

I don't see why not .... I have not had my stock bumper in years .... worse case scenario, you might have to fab some sort of spacer to move the bumper out some

ok here goes ..... between the frame rails is a piece of 3x3 1/4 wall steel, welded below it is another piece, the tabs of the 3x3 are 3/8 steel it is solid as a rock ... here is what one loos like not installed ...my front springs a 6 in chevy springs 44 1/2 in eye to eye the only difference...

did u remove the c clips??????????