Hello Guys, I need your help. I recently had to replace the main rear seal on my father's 96 Ranger 3.0.
When doing the work, we decided to replace the transmission hydraulic fluid and filter. We used Merkon V fluid from Walmart and Duralast filter and gasket. The old fluid did not smell burnt...
Hello. I have replaced the axle bushings. the driver's side was no problem, I was able to center the bushing in the axle hole. The problem is the other side, if I center the bushing in the axle hole, the axle rubs against a part of the chassis, so I had to leave the bushing flush in the part...
Hi. I am going to install new head gaskets and bolts, and according the manual the torque is specified in two steps:
Step 1: 33 to 41 Ft-lbs
Step 2: 63 to 73 Ft-lbs
I am going to clean out the threads with a chaser APR M11x1.5 and apply a thin coat of anti seize copper grease on the new head...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.