Latest activity
-
Jazzer reacted to Rick W's post in the thread What did you do to your Ranger today? (Part Deux!) with
Like.
Radio update. The two Lincoln radios look very similar to the Ranger radio, and they slide in the dash perfectly. The plug with the... -
Rick W replied to the thread What did you do to your Ranger today? (Part Deux!).Radio update. The two Lincoln radios look very similar to the Ranger radio, and they slide in the dash perfectly. The plug with the... -
finally got the squeaky belt idler pulley replaced on my escape, what a pain! remove rf tire, remove a underbody splash shield (which...
-
rusty ol ranger replied to the thread Radio shack vs Amazon.I dont use crapazon any more. For anything. Same shits on ebay and you dont have to have a membership for free shiting -
Heres what i did today.... I had 2 round bales on the little trailer. Didnt look that deep....but it was. My buddy was on his way to...
-
Rick W replied to the thread turn signal woes.If it’s anything like my 87, that multifunction switch actually comes out pretty easily. 1. Remove the steering column cover (two...
-
rusty ol ranger replied to the thread bullnose 1/2 ton.Thats a bricknose lol. I seen it...and thought about it. I had an 83 with that drivetrain combo. Bulletproof as hell and that low...
-
hit Rockauto, same switch for 2000 and 2002. check output of multifunction switch pin 9. that's the blink/stop/hazard output to the rear...
-
I have diagrams for a 2000, don't know if 2002 is exactly the same. the multifunction switch has separate outputs for the front and rear...
-
Does the left rear brake light work?
-
The dash turn signal indicator does flash. This left rear bulb does not flash with the hazard flasher either.
-
SenorNoob reacted to pjtoledo's post in the thread About to start front suspension rebuild with Like.
the bearing races are harder than the spindles. the spindle can wear enough to allow the races to move. the wear will be on the bottom... -
pjtoledo replied to the thread About to start front suspension rebuild.the bearing races are harder than the spindles. the spindle can wear enough to allow the races to move. the wear will be on the bottom... -
Jay11 replied to the thread 2.5L ('98-'01) Oil Leak.I am gonna replace the radiator due to a leak. I just flushed the engine but it needs more flushing. So I decided to add preston rad...
-
SenorNoob replied to the thread bullnose 1/2 ton.Looks pretty clean underneath for something that old in Ohio. Looks about like my truck and AFAIK it's only been north of Kentucky once...