tube header

[4b316]

Is the 94 tube header a direct bolt in for the older 8 plug head?To the exhaust pipe?O2 sensor?

 

[Dave R]

The '94 was an 'older' 8-plug head.

 

[scotts90ranger]

being under a '94 this past weekend, the only difference I noticed between the header and the cast manifold on my '90 is the EGR, it looked like it was at a different angle, but didn't look at them close enough together to know for sure... the EGR system on the '94 is definetely different than the '90...

 

[4b316]

Sorry,maybe didn't make myself clear.I wanted to know if the tube header would fit on the eariler 8 plug head with the cast iron manifold without a lot of change,IE to the egr pipe,to the exhaust pipe.

 

[psmith]

sorry to bump this thread, but i have the same question.

i have a 1990 and need to replace the cracked (cast) exhaust manifold. will the later (tube) "header" style manifold bolt directly to my 1990??

thanks in advance.

 

[TireIron]

It will defintly bolt to the block, and it may bolt to the rest of the exhaust or not, i dont know where it sits compared to how far the cast manifold goes to. If you grab one from a yard you can grab the EGR tube also in case it is slightly different.