-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Truck part art
- Thread starter Todd
- Start date
Danger-Ranger96
Well-Known Member
- Joined
- Aug 14, 2007
- Messages
- 464
- Age
- 36
- City
- Edmonton, Alberta
- Vehicle Year
- 2010
- Transmission
- Manual
that is awesome man, i bet you could get alot of money making something like that and putting it on the market!
Carlos Murphy
Well-Known Member
Expensive car parts ART...
That's a nice piece, I did a couple of abstract pieces in the early 70's in my first few years with BMW (33 yrs total) wish I still had um.
I made some display pieces for the parts counter display case, I drilled and tapped a piston (off center to clear the wrist pin) and screwed in a spark plug from the bottom so the electrode stuck out the top, installed a plug wire and the con rod...sure made people scratch their heads.
Another one was just a TO bearing with a inline fuel filter in it with a tag that read "clutch filter".
Oh yah, how much dose it weigh?
That's a nice piece, I did a couple of abstract pieces in the early 70's in my first few years with BMW (33 yrs total) wish I still had um.
I made some display pieces for the parts counter display case, I drilled and tapped a piston (off center to clear the wrist pin) and screwed in a spark plug from the bottom so the electrode stuck out the top, installed a plug wire and the con rod...sure made people scratch their heads.
Another one was just a TO bearing with a inline fuel filter in it with a tag that read "clutch filter".
Oh yah, how much dose it weigh?
Last edited:
AgPete139
09/2014 OTOTM Winner
Supporting Member
OTOTM Winner
Solid Axle Swap
TRS 20th Anniversary
TRS Event Participant
- Joined
- Aug 12, 2007
- Messages
- 2,866
- City
- Houston, TX
- Vehicle Year
- 1997
- Engine
- 4.0 V6
- Transmission
- Manual
- Total Lift
- ~9"
- Tire Size
- 35"x12.50"x17"
Looks really good...I was impressed myself. You have good insight... 
- Joined
- Aug 7, 2007
- Messages
- 478
- City
- Troll land
- Vehicle Year
- 90/92/99/04
- Engine
- 4.0 V6
- Transmission
- Manual
- Tire Size
- 42
Ya I was thinking of that too, but im not sure I want to make one agian. I mean it at times really sucked. Holding tinny little metal chunks while trying to strike the arc, burning my fingers through thick gloves. I had good motive I guess for making it
Shes worth the time and pain I spent.About 30 pounds.
Thanks again for all the comments
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
