TRS fab & offroad spindle kit 707166X

[ecablarn]

Just a quick question on this part from TRS. Does any one know all the parts in this assembly / kit? Is there one spindle, one bearing, and one seal, or another combination? I will be needing them from my restoration project! Thanks in advance.

 

[ecablarn]

Well after some research and web surfing TRS fab and offroad was the cheapest, but were out of stock till july 09.
So, I had to go with bronco graveyard as my other choice. Local driveline shop or Ford dealer were some others.

The 707166X is what it says a kit from dana/spicer consisting of one spindle and its sub-components which are one small axle shaft bearing and one small seal on the inboard and interior side of spindle.
They even came with some pieces i wasn't expecting for the axle shaft such as the axle shaft oil ring seal, nylon spacer, and the axle shaft oil ring/slinger which is pressed on the axle shaft itself. (everything you need to seal the end of the shaft 5 to 6 pieces depending if you get the updated spindle seal and spacer piece as one unit an updated design)

* Note ---- (these are not always shown by the picture presented)

FYI - for those who are in my position - BEFORE - as I was