Sliders!

[atvkid4eva]

Hey guys these are the first thing I've made using my new JD2 Model 3 bender works awesome! Also i used the harbor freight notcher and with minor shimming and a good hole saw it works great! The middle supports still need welded in since i ran out of welding wire . Will post more pics when i get them mounted. Enjoy

 

[JohnnyU]

What size tubing, they look kind of small, 1.25"?

 

[88_Eddie]

they look good, nice work....might add another mounting point in the middle

 

[atvkid4eva]

1.5" tube..and there is gonna be three mounting point to the frame. Gonna just cap the end off.

 

[norcals91]

Looks good, just picked up a model 32 myself and can't wait to start bending. Make sure to reinforce a plate on the frame before welding those on because it will flex that c channel frame for sure.

 

[86 slo-vo]

1.5" tube..and there is gonna be three mounting point to the frame. Gonna just cap the end off.

i would deffinantly add some triangulation into your mounts or they are just going to flex way up if they ever gut used.

 

[atvkid4eva]

triangular gussets where they mount to the frame? Is that what your talking about? I was planning on that.

 

[97TrailRigDD]

The tube going from the frame to the slider is so long that just 3 pieces of tube unsupported will not hold the weight of your truck . I put 1/2 by 1 1/2 bar on edge on top of the tube , it helped but still not enough . The RBVs frame rails are a lot closer together than other trucks like Toyota trucks .