- Joined
- Nov 8, 2025
- Messages
- 4
- Points
- 1
- City
- Weiser
- State - Country
- ID - USA
- Vehicle
- Ford Ranger
- Drive
- 4WD
- Engine
- 4.0 V6
- Transmission
- Manual
- Tire Size
- 265/75/R16
I pulled a gauge cluster from a 2002 Mazda truck to put on my 2001 Ranger XLT and assumed they were the exact same until I saw there was 1 resistor missing from factory on the back. I was hoping it was just design changes but my THEFT light isn’t blinking. Can I just solder the resistor onto this one or will I have to live without PATS? I really don’t want my truck to be stolen.
Gauge cluster I’m putting in is missing the 220ohm resistor to the right of the ant theft led.
Gauge cluster I’m putting in is missing the 220ohm resistor to the right of the ant theft led.
