New Guy Here...

[Troy94]

I have a 3/4 lower (semi-custom...) was just wondering if anyone could help me figure some stuff out with the alignment of my truck.
Its my daily driver so i can't afford to keep putting tires on it...
Anyone care to throw some advice my way??? It would be greatly appreciated thanks

 

[constant_projecttruck]

Well how is it lowered in the front (I hope by semi-custom you didn't cut them coils ) but you should start with getting some adjustable camber eccentrics and see if that helps.

 

[Troy94]

yes i did =( but i have some'2inch lowering coils" from summit
but... where would one find these "camber essentrics?"

 

[sparkdic]

The best ones I've found are at Napa and were pretty cheap compared to any place else.

 

[slammedxonair]

a 3 inch coil drop is pretty much maxing out the alignment. your best bet is to get the +-4 degree camber caster eccentrics from napa part #264-3950 and then take them with the truck to an alignment shop.

 

[Troy94]

thanks for all the input guys
this is my first time on a forum and it proved to be extremely helpful
i will let you guys know what happens after i get all the parts and such
thanks again

 

[7.5L_STX]

hey..........\/