Need Help With Rebuild

[lbergstreser]

I am current;y rebuilding a transimission for an 88 Ranger, 5 speed manual, 4 wheel drive. On on of the shafts there is a pin that is used to keep a gear or bearing from slipping but I cant figure out how to get it out.

I have tried chisseling and using air tools but all it does is break and dent the bit because it is obviously hardened steel. Any suggestions please?

 

[olranger]

what about drilling it out

 

[dennis461]

can't drive it out with a hardened steel drift pin?

 

[BRUTUS_T_HOG]

drift pin is the only way. you need HARD metal.... and drilling is not an option.

pics would help too

 

[lbergstreser]

Thanks for the advise, but I ended up having a tranny shop finish it. One last question though...

What is the fluid capacity for the 88 Mazda Tranny (manual) in this truck?