My trucks current undergoing.

[Original_Ranger84]

Nothin special, just doing my GM module nonfeed back system on my truck and get rid of the feed back carb and computer.

All of the wires that were sitting on my engine:

My dirty little engine I can see finally!

The new analoge module and how I'm wiring it:

Another clean view of my engine:

And the computer that I can't figure out how to remove? and how do I get all of the wires out as well?

along with that I finally got my transmission fluid changed after I rebuilt it like 1,000 miles ago. It now run full synthetic Royal Purple gear oil!

 

[ZMan]

always good to get rid of unneeded crap. The computer is easy to remove. There are 2 screws that go into the sheetmetal that hold that plastic bracket to the kickpanel. Then just unplug the wiring from the computer (its bolted to the computer), unbolt the ground, and pull the wiring out through the engine bay.

 

[Original_Ranger84]

Thanks I wanna drive it again.