Lower control arm bushings.
- Thread starter heptofite
- Start date
- Joined
- Oct 25, 2009
- Messages
- 1,697
- Points
- 3,101
- Vehicle Year
- 2019
- Engine
- 2.3 EcoBoost
- Transmission
- Automatic
- Joined
- Aug 13, 2007
- Messages
- 3,127
- Points
- 3,101
- City
- Illinois
- Vehicle Year
- 1995
- Transmission
- Automatic
Doesn't hurt to ask now does it? A beam could be considered an arm and it is below the coil spring....is it not? And it does have a bushing at the pivot. I did want to assume it was an SLA setup, and wanted to ask first in order to be on the same page.
From my experience, a ball joint press kit works quite well. You may need a regular shop press......but the ball joint and a 1/2" impact have worked most the time for me.
Also be sure to mark the depth of the bushing, and try to match it the best you can.
From my experience, a ball joint press kit works quite well. You may need a regular shop press......but the ball joint and a 1/2" impact have worked most the time for me.
Also be sure to mark the depth of the bushing, and try to match it the best you can.
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
