Little night wheelin trip

[Danger-Ranger96]

Hey guys, just got back from a wheelin trip, started it at about 5 pm my time (mountain time) and got home at 9pm.

anyways heres some videos and pics from the night, we had to cross a river to get to most of the good wheeling trails.

http://media.putfile.com/MVI-0238
http://media.putfile.com/MVI-0265

Me chillin' heh

the 2nd video is just me going up a little bit of an edge that was cut for quadders, my friend with the stocker had a bit of a time getting up it but 4 low crawled me right up, no sweat

it doesnt look like much in the video so i just took a few pics of it, there were a few rocks to work around. Still doesnt look like much but the ledge is a good foot and a half.

Also when my friend with stocker when up it he bent his tail pipes a bit, heh so much for his bling bling i guess:

We're planning on going again tomorrow with hopes in getting better pictures and videos, its hard taking good videos at night with limited light haha

 

[camodown]

looks like fun, and that is the reason why, if you wheel, you don't get dual exhaust straight back. Seen bent pipes a lot haha

 

[Destroyer000]

looks like a lotta fun man that was some DEEP water.. better check out those wheel bearings haha

 

[Danger-Ranger96]

haha yea man, i'm doing my wheelbearings this week so i have to check them anyways lol

 

[King Crush]

That thang sounds bad @$$! What kinda exhaust you got on it? I wish mine sounded like that.

 

[Danger-Ranger96]

Dynomax muffler, with 2.5'' pipes from the headers.

 

[Danger-Ranger96]

Jerry's truck, the guy with the bent pipes sounds pretty sweet too, heres a video of him buckling his tailpipes on the same ledge heh

http://media.putfile.com/MVI-0264

 

[King Crush]

Dynomax muffler, with 2.5'' pipes from the headers.

Nice, I see you got duals. Do you have headers or stock manafolds?

 

[Danger-Ranger96]

no i don't have duals i just have a side exit on the passenger side, and i have stock manifolds. Jerry's FX4 Level II (the blue one) has duals.

 

[Hahnsb2]

Thats why my exhaust runs between my body and frame and comes out before the tire. I got tired of dragging/bending it... I have since cut a notch in the body so it tucks up even better.

 

[Danger-Ranger96]

yea my goes up over the axle and is pretty high up to avoid smackin the ground. My first dynomax got crunched because it was to low.