how to remove neutral safety switch?
- Thread starter ncsdaonex
- Start date
- Joined
- Sep 9, 2007
- Messages
- 1,794
- Points
- 3,101
- Age
- 86
- City
- East Texas
- Vehicle Year
- 1994
- Transmission
- Automatic
No switches on the master cylinder. If it is the manual transmission in your profile, it does not have a neutral safety switch, only automatics have this feature.
Your truck has a clutch triple function switch, and it is located on the clutch pedal at the master cylinder rod inside the cab by the lower steering column. Pink wire which goes to rd/lt blue.
Not sure about the Ranger, but on my F150 the switch slides over a pin on the clutch pedal, and is held on with a cotter pin. Simply remove the pin, and slide the switch off.
shady
Your truck has a clutch triple function switch, and it is located on the clutch pedal at the master cylinder rod inside the cab by the lower steering column. Pink wire which goes to rd/lt blue.
Not sure about the Ranger, but on my F150 the switch slides over a pin on the clutch pedal, and is held on with a cotter pin. Simply remove the pin, and slide the switch off.
shady
Last edited:
- Joined
- Dec 18, 2008
- Messages
- 15
- Points
- 3,101
- Vehicle Year
- 91
- Transmission
- Manual
yeah th ranger has a little c-clip lookin thing thais very easy to remove....but you have to remove the rod from where it connects to the pedal....this has an e-clip...just becareful not to loose it...then the switch will slide off...
why are you removing it?
one time i had one that wouldnt push far enough and i use a peice of rubber hose i split and a zip tie as a spacer...
if you are removing it just so yo dont have to pust the pedal to start it ther are 4-5 wires going to to it...2 that a re for the starting part of it and the others for disengaging cruise/cont...
why are you removing it?
one time i had one that wouldnt push far enough and i use a peice of rubber hose i split and a zip tie as a spacer...
if you are removing it just so yo dont have to pust the pedal to start it ther are 4-5 wires going to to it...2 that a re for the starting part of it and the others for disengaging cruise/cont...
- Joined
- Dec 5, 2008
- Messages
- 181
- Points
- 3,101
- Vehicle Year
- 1990
- Transmission
- Manual
i am removing it because my master cylinder is leaking so im replacing it and i need to put the switch on the new master cylinder. how can i bypass that so i dont have to push the clutch in to start it.
- Joined
- Aug 14, 2007
- Messages
- 7,962
- Points
- 3,101
- City
- UT
- Vehicle Year
- 1989
- Engine
- 4.0 V6
- Transmission
- Manual
- Total Lift
- 5
- Tire Size
- 33
You can bypass it by connecting the two Pink or Red wires going into it.
But, I suggest reusing it tho.
But, I suggest reusing it tho.
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
