- Joined
- Dec 23, 2011
- Messages
- 31
- Points
- 1,601
- Transmission
- Automatic
I'm putting my Dana 35 back together and am looking for the best type of grease to use on the hubs and bearings. Thank you
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Grease for From axle reassemble
- Thread starter welderman85
- Start date
- Joined
- Sep 15, 2013
- Messages
- 430
- Points
- 1,601
- City
- Las Vegas Nv.
- Vehicle Year
- 2020
- Engine
- 2.3 EcoBoost
- Transmission
- Automatic
- Tire Size
- 265/65/17
Hightemp disc bearing grease for the bearings and for the manual hubs make sure they are very clean and just get them a little wet with atf.
- Joined
- Aug 19, 2001
- Messages
- 10,908
- Points
- 5,101
- City
- So. Calif (SFV)
- Vehicle Year
- 1990
- Engine
- 2.9 V6
- Transmission
- Manual
- Tire Size
- 35x12.50R15
The hubs should have a very light film of grease on all their parts, but definitely do not pack them full of grease or they won't work right.
×2, a good high-temp lithium-base disc-brake wheel bearing grease is fine. I've used Sta-Lube and Castrol greases before, and stuff in a blue can called "Peak High-Temp Red Grease" (IIRC) currently.
×2, a good high-temp lithium-base disc-brake wheel bearing grease is fine. I've used Sta-Lube and Castrol greases before, and stuff in a blue can called "Peak High-Temp Red Grease" (IIRC) currently.
Sponsored Ad
Sponsored Ad
Special Events
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
TRS Latest Video
TRS Merchandise
Follow TRS On Instagram
