exterior accessories

[MAXDA]

Does 1994 ranger reg cab accessories fit 1994 b-4000 reg cab? I know from looking at all the posts Same truck except body.i.e. like brush guards,steps etc. Maybe with a little modification?Thanks

 

[blkmazda90]

going out on a limb here. but i believe just about anything off a ranger will fit a mazda from like early 90's to 96 or 97. Not a 100%

 

[redneckbl89]

the grille guards for the ranger wont fit. i allready tried. the mazda and the ranger have a different designed bumper. as far as nerf bars go it should be the same because the have the same frame. as far as a grille guard goes for a mazda, it took me almost a year to find mine and it was the last one they had. cant remember where i got it from. all i know is it's made by grizzly.

 

[dirtsquirt]

the grille guards for the ranger wont fit. i allready tried. the mazda and the ranger have a different designed bumper. as far as nerf bars go it should be the same because the have the same frame. as far as a grille guard goes for a mazda, it took me almost a year to find mine and it was the last one they had. cant remember where i got it from. all i know is it's made by grizzly.

You were lucky and must of found some old stock (grizzly ) is no longer. It's to bad to they made a pretty good product.

 

[MAXDA]

Thanks for your replys.At least I know I'm not crazy been looking all over the internet for them.I'll try to locate the one you stated thanks.

 

[Donnie strickland]

I had a 94 Mazda; but now I have a 94 Ranger, so I'm working from memory...

As previously pointed out, grille guards are not the same; neither are front bumpers. On these trucks, the cab itself is the same -- doors, windshields, back glass, anything for the interior, etc.

But: the fenders, hood, and grille will not interchange. Basically all of the body forward of the windshield is different.

The frame seems to be the same.

The bed is the same with the exception of the taillights. They're just enough different so they won't interchange. The tailgate is the same, as is the rear bumper.

All of the mechanicals seem to be the same, at least the parts that I tinkered with.

It's not much but I hope it helps.

 

[Hecklin at y'all]

Is it possible to replace the front body parts of the Mazda with those of a Ranger?

So I remove the fenders, bumper, hood, and install these parts from a Ranger.

Just expanding on a thought.

Tim...also expanding at the waist.