engine has no power than all the sudden it gets power

[majdi]

okay so i finally got my truck running after 4 engine swaps lol

so this is what happens, when the truck starts, it idles rough and engine shakes, i give it gas when its in park and engine revs up fine no problem

when i start driving it will have its full power that im used to for like 20 second than the truck will have no power i would floor the pedal and the truck wouldn't go it would maintain the rpm and not increase speed i would press harder on the peddle although its on the floor it would rev up high and shift and rev high and shift but no power, and after 3-4 min it will get its power back for like 30 seconds than were back to no power

checked vaccum leaks, replaced plugs, wires, coil pack, the maf sensor was also replaced , replaced the upper intake so all the sensors that are on it were swapped i guess , i have three upper intake manifolds

still having the same problem, my last engine was hydro locked had bent rods

check engine would go on and off randomly, i can't remember but i think when it turns off or as soon as it turns off i get the power of the motor back.

engine throwing codes , something to do with the octane mixture or something like that


please help

thanks

 

[Rifleman]

Engine and PCM match? Sounds like you may have put an engine in with sensors that are incompatible with the PCM.

 

[majdi]

engine is out of a 94 explorer, the engine before it was from the same year arerostar, that one ran fine ?

 

[majdi]

my truck went through some deep water, it was over the hood but i was out right away and that's when it hydro locked, could it be that the ignition modual got wet , would it cause this ?

 

[majdi]

also oil pressure is showing not so normal its at the very beginning of the letter N but usually its in the middle of the word Normal

 

[majdi]

k figured out the problem, i started to unplug sensors and see what they did to the engine, started with the tps, and guess woot my truck got its full power back, so i left it unplugged, drove 300 km and its pulling strong, it just idles ruff and and when stop and go it lags for a second before going, i unplugged the maf sensor, it had some power back but not as good as when i unplugged the tps . could it be the harness to the tps or the tps it self.

thanks