• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

EGR block off plate?


Get a piece of metal, trace out the gasket for the EGR valve, and cut/drill one of own. I've made more than one that way.
 
+1 ^^^

The intake just has vacuum pressure sucking in on the Plate, so plate doesn't need to be super thick metal, just air tight
 
I have made a lot of this also
 
You could just disconnect and plug the vacuum supply to the valve, disconnect the power to the vacuum control solenoid, or realize there’s no benefit to disabling it and leave it be.
 
You could just disconnect and plug the vacuum supply to the valve, disconnect the power to the vacuum control solenoid, or realize there’s no benefit to disabling it and leave it be.

EGR is more problematic on a carb than it is on EFI.
 
I also did the Duraspark swap so I had no need for it. I made a plate of 1/4 stock I had laying around, works great.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top