TiredButStillRollin94
Member
- Joined
- Dec 12, 2008
- Messages
- 7
- Vehicle Year
- 1994
- Transmission
- Manual
Hi, I don't want to start a war being the New Guy but I've had a lot of experience making "Custom" exhausts since I learned to weld. I was ten at the time I think. My first stack was on my friends 1955 IH one ton. (220 Silver Diamond Straight Six). I used a Ford Driveshaft tube for the stack. It was really Tuff sounding! I have searched a lot on the web for dual stainless stacks that others have made and all I find is the soot Blowers with Mongo Pipes. They think it's wussy to put them on a gas Job. They never ran a good setup is all I can say. Here's my 94 Ranger with the pipes I used to run on my 74 Chevy stepside PU that had a 250 straight six banger. It had close to 300K when the body finally gave up the ghost. They aren't hooked up on the Ranger yet as I was gathering Stainless elbows and such on Ebay for it.
They are rather small in size "Comparatively" but really sound awesome with no muffler. 1 3/4" OD Stainless Pipe. They are fairly tame noise wise unless you want them to talk! The sound goes up! I get lots of compliments on them. I know I just have a beater and I'm a redneck, but Hey, I'm havin' Fun! Paul 

