danna 30 ?

[xr75er]

just found a danna 30 full set up on cl for $200. springs included. guy was going to use it on an s10 sas. My? is this a good set up for a sas on my 86 b2.
??????

 

[superds]

What was it from? A Jeep? It's probably ok if it's from a Jeep Wrangler or XJ, it would have same wheel bolt pattern and strength wise might be a little weak if you were doing extreme wheeling or had lots of power. Not sure what the width of such an axle would be but I imagine it being fairly close to the Ranger if it's from the Wrangler or XJ.

 

[xr75er]

High Pinion Dana 30 out of a 1989 jeep wrangler yj.

 

[Beanmachine7000]

Do a search it's been done a million times... Too weak really for a Ranger, but might survive if you don't beat on it, same width, same bolt pattern...

 

[nate09]

strength wise it falls short of the dana 35, but should do fine if you stay 33" tires and dont do anything crazy with it.

 

[xr75er]

Thanks All

 

[Insanejughead]

There's a article on it that was done from a guy I know who lives in Warrensburg, MO. It's in the tech section.

I still bug the guy about thunderbird/mustang related stuff.

 

[rangertoy]

I think a HP Dana 30 will be fine under you B2. I have had one under my ranger for almost a year and have 38.5" tires and beat the hell out of it and have had no problems, yet