Dana 44 TTB in a Ranger

[rustyballs]

just wondering if I have this correct,if I move the pivot bolt holes out 1 inch (towards the fenders) I can run a the fullwidth ttb in my 1989 or is there alot more to it,I have fiberglass fenders and bedsides,and what about radius arm brackets.any help would be great.

 

[dusto2]

iirc you move them in towards each other about 3/4" and then you have a full wideth setup, you will probably have to look into some coilovers for it, this is something i have been looking into for my next ranger, talk to notallthere he has 1 in his race truck

 

[odie1969]

You will either move the pivot point in a inch, or cut and respline the Pass. side axle a inch. you can also extend the beams about a inch. and for the springs you can use coil overs, kinda pricey. Or you can remove you coil buckets and space them out to the correct postion.(most likely what I will do)

Look in the tech area for more info. also ask 4x4junkie, simonsays, and notallthere these folks have already done this swap.